Primax Industrial Paints

Air Drying Hammer Finish

  • Decorative protective coating
  • Producing a variety of hammer tone effects
  • Good interior and exterior durability
  • Widely used for steel almirahs,  toys, electrical appliances, optical instruments
  • Extensively used for decorative articles

DESCRIPTION
A decorative protective coating producing a variety of hammer tone effects, depending upon technique of application. It abrasion resistance have good interior and exterior durability.

USES
It is being widely used on preference for steel almirahs,  toys, electrical appliances, optical instruments and for decorative articles.

PACKING
3.64 Liters.
COLOUR
A selective range of colours available.
COMPOSITION
Aluminum and tinting pigments dispersed in selected alkyd resin medium.
THINNER
Special thinner for hammer finish / Petrol.
DRYING TIME
SURFACE DRY
40 Minutes – 1 Hours
TACK FREE
2-3 Hours
HARD DRY
24 Hours
CAPACITY
11-12 meter square / litre, also depending upon application technique.
VOLUME SOLIDS
43%       
FLASH POINT
24 degree C
GLOSS
Full gloss

APPLICATION
Conventional spray.
SURFACE PREPARATION
Remove all rust, dirt, and grease by wire brushing and scraping. Clean the surface with cloth soaked in solvent and apply Primax Hammer Finish after applying Primax Paint. Universal Synthetic Undercoat if required. Thin the hammer finish by point 4:1 Petrol. The air pressure should be 50-60 PS1. The speed of the gun should be traversely steady to get the hammer effect.

Show Buttons
Hide Buttons